How to solve the problem of jaw crusher not cutting

Time：2022-06-01 15:27:46 Share To

　　When the jaw crusher is crushing the ore, it often happens that the material is stuck. Jiaozuo Xinhai Mining Machine Mining Machine will introduce the solution to this situation.

　　When the jaw crusher encounters materials with large surface moisture, or when the crushed materials are mixed with mud, it is very easy to jam the materials, so that the minerals cannot come down, and the ore is blocked in the cavity after being crushed.

　　In this case, the following methods can be used:

　　1. Reduce the spindle speed and increase the discharge port;

　　2. Adjust the discharge port, but the angle should not be too flat;

　　3. Pre-screening, and appropriately increase the discharge port to increase the discharge efficiency;

　　4. The methods of pre-screening, pre-washing, and ore blending to control moisture are adopted, but some ores are more difficult to handle;

　　On the other hand, before using the crusher, it is necessary to understand the basic requirements of the crusher for the material. As far as jaw crusher is concerned, for example, what needs to be crushed is sulfur ore; because sulfur ore is mixed with a lot of soil, correspondingly, there are more mixtures in the material, and the temperature of the material is too high, which will lead to the crushing process. The viscosity of the material in the middle is too large, which causes blockage before crushing. Therefore, in this case, it is necessary to ensure the dryness of the material and the purity of the material before crushing the material, so that it does not contain too much mixture. If you want to strengthen the service life of the crushing plate of the jaw crusher, it be improved from the process of equipment and material selection, assembly and use, so as to improve the production efficiency of the jaw crusher and reduce the production cost.